Rachel Vaughn Sailboat February 13th, 2018 - 13:36:59
The final step is to place all the sailboat winch parts back into the base where they belong. If you do end up with extra parts youll have to go back through each part and play detective until its home is discovered. Also its not a bad idea to periodically give the shaft and gears a spin to make sure you are on the right path. Remember in most cases sailboat winches are used in pairs. Clean one winch at a time. If you become confused as to where a part goes you can look at its mate for the answer. Final Touches to the Winch Lightly brush on clean winch grease. Do not overpack. Once you are certain the sailboat winch is reassembled correctly lightly brush on some clean winch grease. Some owners think that because they wont get around to servicing their winches for a long time the smart strategy is to pack them with so much grease they will last for years. This is a bad idea and only makes a big mess down the road.
This fascinating hobby is enjoyed by people of all ages around the world. Model boat building is almost as old as recorded history and examples dating back to Phoenician and Ancient Egyptian times may be found in museums. Although model sailboats were originally made for ceremonial or religious purposes early examples have also been found that appear to have been made just for fun. For many years scale boat models were also used in boatyards instead of drawings to explain what was required to craftsmen who did not know how to read drawings. Radio (RC) controlled model sailboat building has become a popular hobby throughout the world thanks to greater disposable income and increased leisure time. Modern technology has made it possible for anybody with funds and access to open water to own and operate a remote controlled sailboat that looks and behaves like the real thing.
After soaking take the small brush and work off any old grease from the winch component. Dont forget to clean the winch gear ring on the inside of the drum. Now that youve removed the grease and grime rinse the parts in hot water to remove the mineral spirits. If the spirits are left on it breaks down the grease. Dry the parts with a clean rag or paper towel. Reassembly of Sailboat Winch As you put the gears back into place take a close look at how the pawls are working. If they dont open and close smoothly then the drum could spin backwards. If theres any question that the pawls are not working properly it is much easier to replace them and the little springs. It is very important NOT to grease the pawls because grease causes them to stick. And if they stick the gears wont engage. To lubricate your pawls use any light oil that might be on hand; something like a 3 & 1 oil.
As far as the traditional monhull sailboats that most people are familiar with the most common of all of them are the single mast sailboats. Also known as a sloop these sailboats have a single mast that is either set into or stepped to the hull or the deck of the ship. This mast supports two sails the mainsail and the headsail (sometimes referred to as the jib). The mainsail is the aft sail and the headsail is to forward sail. The catboat and the cutter are two variations of the sloop. The catboat has the mainsail at the front of the ship and the cutter holds the mast aft and can commonly feature two jibs along with the mainsail. Having a single mast sailboat is easier to control and maintain and therefore is the most common sailboat for schools and lessons.